Label making machine Flexor
Paper-, board-, corrugated converting machines

Technical data:
Description:
Used label making machine:
max.web width: 380 mm
max.speed: 300 m / min
Unwinder:
Max.roll diameter: 800 mm
Pneumatic unwinding spindle: diameter 76 mm
Programmable end of roll
Single rewinder:
Max.winding diameter for individual winding: 500 mm
Pneumatic unwinding spindle: diameter 76 mm (easy spindle change)
Winding spindle with its own servo drive for precise winding tension
Winding tension is given in Newtons: 1 module
Cutting unit:
Longitudinal cutting unit with transverse register +/- 7 mm and cassette insert: 1 set
Setting unit for the shear blades outside the machine
Shear knife set (upper and lower knife) 12 pieces
Minimum. Width of the longitudinal section: 20 mm
Cutting between two servo driven preferred shafts: 1 module
Web tension control:
Complete control of the rewind tension thanks to servo-controlled rewinder
Pneumatically controlled preferred shaft with its own servo motor
Diameter control on all shafts (unwinding shaft, winding shaft, lattice shaft): 1 module
Counter:
Meter and decimeter counter
Label counter for transparent labels
Automatic calculation of the braking distance
Daily production counter (only counts when the machine is running)
Total machine runtime counter
Total wrapped meters
Ergonomics:
E + L web edge control with built-in splice table with pneumatic terminal strips
PLC controlled system / touch panel in German
Roll end bracket
Antistatic brush
Foot pedal (jog / stop)
Additional control panel in the rear area
250 job memories
Equipment:
Missing label unit max. 12 lanes: 1 module
Missing label sensors for normal labels: 10 pieces
Waste paper take-up with 76 mm expansion shaft
- max.winding diameter 400 mm
- max.speed 30 m / min
- 76 mm expansion shaft
- Position can still be defined
Technical specifications:
Length: 3550 mm
Width: 1620 mm
Height: 1900 mm
Mass: 3000 kg
Voltage: 3x400 V / 50HZ
Power: 16.5 kW
Air requirement: min. 6 bar